Manufacturers in CNC lathe overhaul four common faults

The information value displayed on the control panel is inconsistent with the actual cutting value of the CNC machine tool manufacturer: This common failure is mostly related to the part inspection component and is caused by the loss of a single pulse during the rapid cutting process.

After the system is started, the system is stuck: generally because the statistical data of the CNC machine tool manufacturer is confused or inadvertent factors make the system enter an infinite cycle, and the CNC machine tool manufacturer must restart after standby during overhaul; If troubleshooting is not possible, all operating memories must be cleared and the main parameters of the CNC machine tool re-entered.

Continuous operation of the lathe tool holder or the required tool position cannot be accurately positioned: the cause will be a short circuit of the transmission disk wire connector or power plug, a short circuit or short circuit of the Hall element, repair or replacement of the relevant element

The lathe tool holder suddenly stops running, the motor vibrates and does not run: manually rotate the handle, and if a part is too heavy or stuck, it is a mechanical equipment problem, such as dirty things in the steel ball wire dovetail guide rail: if the full-length part is relatively light, it is identified as drilling too deep or cutting too fast.

Alarm solution: Under normal circumstances, when there is an error alarm number on the display, you can view the "error code table" of the maintenance manual to find out the cause of common failures and take effective countermeasures.